This is a corrugated belt conveyor, and it is used in a MATERIALS HANDLING PLANT. It works as an Elevator Conveyor to feed a tow silo. Conveying Angle Degree: 90 Degrees, Belt Width: 1200mm, Lift Height: 43.36m, Capacity: 276 t/h.
General Data | ||
Items | Unit | Detail Spec. |
Design Mass Capacity | t/hr | 276 |
Volume Capacity | m³/hr | 276 |
Belt Width | mm | 1200 |
Horizontal Length | m | 15.43 |
Lift Height | m | 43.36 |
Slope of Conveyor | Degrees | 90 |
Belt Speed | m/s | 1.6 |
Capacity at 100% Cross Section | t/hr | ~ |
Filling Ratio | % | 69.2 |
Counter Weight | Kg | ~2400 |
Material Data | ||
Materials | ~ | Lime and Dolomite |
Lump Size | mm | 20~50 / <60 |
Bulk Density | t/m³ | 1 |
Surcharge Angle | Degrees | 16 |
Sidewall Conveyor Belt | ||
Top Cover Thickness | mm | 6 |
Bottom Cover Thickness | mm | 3 |
Loop Length | m | 120 (The Needed Length) |
Normal Belt Tension | KN | 65.7 |
Starting Belt Tension | KN | 73.9 |
Side Wall Height | mm | 300 |
Side Wall Width | mm | 75 |
Cleat Height | mm | 280 |
Cleat Deepth | mm | ~ 110 |
Cleat Pitch | mm | 260 |
Conveyor Idlers and Pulleys | ||
Drive Pulley Dia. | mm | Ø1025 |
Lagging Thickness | mm | 12.5 Diamond Lagging |
Tail Pulley | mm | Ø1025 / Ø1215 |
Lagging Thickness | mm | 12.5 Flat Lagging |
Bend / Snub Pulley | mm | Ø1025 |
Lagging Thickness | mm | 12.5 Flat Lagging |
Carrying Idlers | mm | Ø133, Ø25, 0 Degree |
Impact Idlers | mm | Ø133/89, Ø25, 0 Degree |
Guiding Idlers | mm | Ø133, Ø30, 90 Degree |
Vertical Guide Idler | mm | Ø133, Ø25, 0 Degree |
Return Idlers | mm | Ø133, Ø30, 0 Degree |